- Universal set with 10 pieces 9.5 x 9.5 cm, 2 pieces 10 x 20 cm, 2 pieces 6 x 20 cm, 2 pieces 5.5 x 16.5 cm, 2 pieces diameter 8 cm, 2 pieces
- Highly stable PVC material
- Transparent
- Permanently self-adhesive film
- Prevents scratches and damage to paint and carrier
The paint protective film bicycle carrier is an affordable, quick and easy way to avoid paint damage and thus contributes to the value of the vehicle. The 10-piece universal set made from highly resistant PVC material is easy to apply and suitable for most standard rear carriers.
Tip: can also be used directly on the bicycle carrier. Prevents damage when storing (parking on the garage floor) or by contact with the bike.
- Universal set of 10 pieces.
- 9.5 x 9.5 cm, 2 pieces.
- 10 x 20 cm, 2 pieces.
- 6 x 20 cm, 2 pieces.
- 5.5 x 16.5 cm, 2 pieces.
- Diameter: 8 cm, 2 pieces.
- Highly stable PVC material.
- Transparent
- Permanently self-adhesive film.
- Prevents scratches and damage to paint and carrier.
- 3D deformable.
- Removable.
Additional tools: squeegee; cutter knife; Foliatec.com premium microfibre cloth (item no. 31920); hair dryer.
- The contact points of the bicycle carrier on the paint are best found when you mount the bicycle carrier. The contact points e.g. mark with a pencil or tape. The film may with a cutter.
- Processing in a place protected from wind, dust and direct sunlight, the ideal processing temperature of the film is between 15 °C and 25 °C. Thoroughly clean the surface on which the film is to be applied from grease, dust and polish residues. To clean, use silicone remover, isopropanol or alcohol (no spirit or washing spirit). Rub the surface dry with a lint-free cotton cloth.
- In a spray bottle (plant pollinator) approx. Mix 1 litre of water with a teaspoon of standard detergent.
- To avoid fingerprints on the film, first spray fingers with the water/dishwasher detergent mixture and then gently remove the film from the backing paper. Spray the adhesive side and then the surface on which the film is to be applied.
- Position or align film on the surface. Press the film evenly and lightly. Using the squeegee, brush the excess liquid outwards starting from the middle. Remove or soak up the squeegee liquid with a cotton cloth. When turning around the edge, it is recommended to work with your fingers. If the film does not stick immediately, heat the film slightly with a hair dryer.
- After approx. 72 hours, the residual moisture is completely evaporated and the final adhesion is reached.
Tip: We recommend leaving the film on the paint for a maximum of two years. After that, it must be replaced.
